Documentation

Sign

Indicate sign of input

Library

Math Operations

Description

Block Behavior for Real Inputs

For real inputs, the Sign block outputs the sign of the input:

InputOutput
Greater than zero1
Equal to zero0
Less than zero–1

For vector and matrix inputs, the block outputs a vector or matrix where each element is the sign of the corresponding input element, as shown in this exampleexample:

Block Behavior for Complex Inputs

When the input u is a complex scalar, the block output matches the MATLAB® result for:

sign(u) = u./ abs(u)

When an element of a vector or matrix input is complex, the block uses the same formula that applies to scalar input, as shown in this exampleexample:

Data Type Support

The Sign block supports real inputs of the following data types:

  • Floating point

  • Built-in integer

  • Fixed point

  • Boolean

The block supports complex inputs only for floating-point data types, double and single. The output uses the same data type as the input.

For more information, see Data Types Supported by Simulink in the Simulink® documentation.

Parameters and Dialog Box

Enable zero-crossing detection

Select to enable zero-crossing detection. For more information, see Zero-Crossing Detection.

Sample time (-1 for inherited)

Specify the time interval between samples. To inherit the sample time, set this parameter to -1. See Specify Sample Time in the Simulink documentation for more information.

Examples

The following Simulink examples show how to use the Sign block:

  • sldemo_fuelsys (in the Engine Gas Dynamics/Throttle & Manifold/Throttle subsystem)

  • sldemo_hardstop

Characteristics

Direct Feedthrough

Yes

Sample Time

Specified in the Sample time parameter

Scalar Expansion

N/A

Dimensionalized

Yes

Multidimensionalized

No

Zero-Crossing Detection

Yes, if enabled

Was this topic helpful?