Documentation

This is machine translation

Translated by Microsoft
Mouse over text to see original. Click the button below to return to the English verison of the page.

Vehicle Network Toolbox Functions

Alphabetical List By Category
attachDatabase Attach CAN database to messages and remove CAN database from messages
attributeInfo Information about CAN database attributes
CAN.ChannelInfo Display device channel information
CAN.VendorInfo Display available device vendor information
canChannel Construct CAN channel connected to selected device
canDatabase Create handle to CAN database file
canHWInfo Information on available CAN devices
canMessage Build CAN message based on user-specified structure
canMessageImport Import CAN message log file from third-party tool
canTool Open Vehicle CAN Bus Monitor
configBusSpeed Set bit timing rate of CAN channel
configBusSpeed Configure bit timing of J1939 channel
connect Connect XCP channel to slave module
createMeasurementList Create measurement list for XCP channel
discard Discard all messages from CAN channel
discard Discard available parameter groups on J1939 channel
disconnect Disconnect from slave module
extractAll Select all instances of message from message array
extractAll Occurrences of specified parameter groups
extractRecent Select most recent message from array of messages
extractRecent Occurrences of most recent parameter groups
extractTime Messages occurring within specified time range
extractTime Occurrences of parameter groups within time range
filterAllowAll Allow all messages of specified identifier type
filterAllowAll Open parameter group filters on channel
filterAllowOnly Configure message filter to allow only specified messages
filterAllowOnly Allow only specified parameter groups to pass channel filter
filterBlockAll Configure filter to block messages with specified identifier type
filterBlockOnly Block only specified parameter groups on channel filter
freeMeasurementLists Remove all measurement lists from XCP channel
getEventInfo Get event information about specific event from A2L file
getMeasurementInfo Get information about specific measurement from A2L file
isConnected Return connection status
isMeasurementRunning Indicate if measurement is active
j1939Channel Create J1939 CAN channel
j1939ParameterGroup Create J1939 parameter group
mdf Access information contained in MDF file
messageInfo Information about CAN database messages
nodeInfo Information about CAN database node
pack Pack signal data into CAN message
read Read channel data from MDF file
readDAQListData Read single value of specified measurement
readSingleValue Read single sample of specified measurement from memory
receive Receive messages from CAN bus
receive Receive parameter groups from J1939 bus
replay Retransmit messages from CAN bus
saveAttachment Save attachment from MDF file
signalInfo Information about signals in CAN message
start Set CAN channel online
start Start channel connection to J1939 bus
startMeasurement Start configured DAQ and STIM lists
stop Set CAN channel offline
stop Stop channel connection to J1939 bus
stopMeasurement Stop configured DAQ and STIM lists
transmit Send CAN messages to CAN bus
transmit Send parameter groups via channel to J1939 bus
transmitConfiguration Display messages configured for automatic transmission
transmitEvent Configure messages for event-based transmission
transmitPeriodic Configure messages for periodic transmission
unpack Unpack signal data from message
valueTableText Look up value of table text for signal
viewMeasurementLists View configured measurement lists on XCP channel
writeSingleValue Write single sample to specified measurement
writeSTIMListData Write to specified measurement
xcpA2L Access A2L file
xcpChannel Create XCP channel
Was this topic helpful?