Hardware Support

Digilent Analog Discovery Support from MATLAB

Low-cost hardware development platform for analog circuit design using Data Acquisition Toolbox


MATLAB® supports the Digilent Analog Discovery™ design kit, a low-cost, portable USB DAQ device. The kit enables project-based learning for analog circuit design. For professors and course instructors, the kit comes with downloadable teaching materials, reference designs, and lab projects.

The Data Acquisition Toolbox™ Support Package for Digilent Analog Discovery hardware lets you perform the following tasks in MATLAB:

  • Read data from the two oscilloscope channels (analog input)
  • Control and generate data from the two waveform generators (analog output)
  • Characterize ICs and measure behavior of the circuit and IC components
  • Configure the sampling rate of the Analog Discovery device
  • Trigger the start of your data acquisition
  • Find and display Digilent Analog Discovery device settings

Platform and Release Support

Available on 64-bit Microsoft® Windows® only.
Prior release support


Related Hardware Support Views: MATLAB, Consumer Electronics, Data Acquisition Toolbox, Digilent, MATLAB Product Family, MathWorks Supported, Project-Based Learning, Signal Processing Toolbox, Support Package Installer Enabled, Test and Measurement, USB

Ready to install?

Before installing the support package, confirm you have the correct setup. View system requirements and installation options.

Get Support Package

Software

Required

Recommended

Support Package

Required

Support Package Installer installs third-party software for this support package. For more information, see the documentation or run Support Package Installer. To start Support Package Installer, go to the MATLAB tool strip, and click Add-Ons > Get Hardware Support Packages.

Get Support Package

Hardware

Required

Recommended

Software

Required

All required third-party software is installed by the Support Package Installer.

Don't see the hardware you're looking for?