Model resistor for circuit envelope analysis
RF Blockset / Circuit Envelope / Elements
The Resistor block models a resistor within the RF Blockset™ circuit envelope simulation environment. For an introduction to RF simulation, see the example, Simulate High Frequency Components.
The block implements the relation
R represents the resistance, as a function of temperature.
i(t) represents the current through the capacitor at time t.
v(t) represents the voltage across the terminals of the capacitor at time t.
RF Blockset current and voltage signals consist of in-phase (Ik) and quadrature (Qk) components at each frequency fk specified in the Configuration block:
Resistance— Resistance value
50 Ohm(default) | real number in ohms
Resistance value , specified as a real number in ohms greater than zero. Specify the units of the resistance from the corresponding drop-down menu.
Simulate noise— Simulate thermal noise
Select this parameter, to simulate thermal noise in a resistor. Then, in the Configuration block dialog box, also select the Simulate noise check box. By default, both Simulate noise check boxes are selected.
This parameter inserts a current noise source with the single-sided power density of 4 kT/R A2/Hz, where:
k is the Boltzmann constant
T is the value of the Temperature parameter, in degrees Kelvin. (Also located in the Configuration block.)