Run Accelerator Mode with the Simulink Debugger
Advantages of Using Accelerator Mode with the Debugger
Using accelerator mode can shorten the length of your debugging sessions if you have large and complex models. For example, you can use accelerator mode to simulate a large model and quickly reach a break point.
For more information, see Accelerator Mode.
You cannot use rapid accelerator mode with the debugger.
How to Run the Debugger
To simulate your model using accelerator mode with the debugger:
On the Simulation tab, in the Simulate section, select
Acceleratorfrom the drop-down menu.
In the MATLAB® Command Window, enter:
At the debugger prompt, set a time break:
tbreak 10000 continue
Once you reach the breakpoint, use the debugger command
(execution mode) to toggle between accelerator and normal mode.
When to Switch Back to Normal Mode
You must switch to Normal mode to step through the simulation by blocks, and when you want to use the following debug commands: