Plot frequency response model in time- and frequency-domain
the following frequency response estimation results:
simoutof the Simulink model
FFT of time-domain simulation
Bode of estimated system
This Bode plot is available when you create the input signal using
frest.Chirp. In this plot, you can interactively select frequencies or a frequency range for viewing the results in all three plots.
frestimate command using the input signal
the linear system
sys in the Bode plot when you
create the input signal using
frest.Chirp. Use this syntax to compare the linear
system to the frequency response estimation results.
Examine Estimation Results Using Simulation Results Viewer
The Simulation Results Viewer lets you examine the results of frequency response estimation frequency by frequency. You open the viewer using the
frest.simView command. To do so, store the simulation data using the
simout output argument of
Estimate the open-loop response of the plant in the
watertank model. First, open the model.
model = 'watertank'; open_system(model)
Define a linearization I/O set that specifies the plant, and find a steady-state operating point for estimation.
io(1)=linio('watertank/PID Controller',1,'input'); io(2)=linio('watertank/Water-Tank System',1,'openoutput'); watertank_spec = operspec(model); opOpts = findopOptions('DisplayReport','off'); op = findop(model,watertank_spec,opOpts);
Then, create an input signal for estimation, and estimate the frequency response of the specified portion of the model. Use the
simout output argument to store the estimation data.
input = frest.Sinestream('Frequency',logspace(-3,2,10)); [sysest,simout] = frestimate(model,op,io,input);
Open the Simulation Results Viewer.
The viewer shows you the steady-state time response and the FFT of that response for all frequencies within the range you select on the Bode Diagram section of the viewer. These plots can help you identify when the response deviates from the expected response. For more information about using the Simulation Results Viewer, see Analyze Estimated Frequency Response.
If you have a linear model of the system you are estimating, you can use the model as a baseline response for comparison in the viewer. For instance, you can compare a model obtained by exact linearization to the estimated frequency response. Use the linearization I/O set and the operating point to compute an exact linearization of the
syslin = linearize(model,io,op);
Open the Simulation Results Viewer again, this time providing
syslin as an input argument.
The Bode Diagram section of the viewer includes a line showing the exact response
syslin. This view can be useful to identify particular frequencies where the estimated response deviates from the linearization.
Introduced in R2009b