Simscape / Electrical / Sensors & Transducers
The Peltier Device block represents a converter between the electrical and thermal energy:
With no current flowing, if the temperature presented at thermal port B is greater than the temperature presented at thermal port A, then there is a positive potential difference measured from the positive to the negative electrical port.
When the block acts as a cooling device, a positive current causes heat to flow from port A to port B, cooling port A relative to port B.
The defining equations are:
QA is heat flow into port A.
QB is heat flow into port B.
TA is port A temperature.
TB is port B temperature.
W is electrical power (positive when flowing into the block).
V is potential difference across the + and - ports.
I is electrical current, positive from + to - port.
R is total electrical resistance.
α is Seebeck coefficient.
K is thermal conductance.
Substituting for powers and dividing all terms by current gives the electrical equation:
The block has a logging variable
power). This variable reports the DC electrical power, that is, the average
electrical power over one AC cycle if you drive the device with an AC source. In terms of
equations it is equal to the instantaneous value of
I2R and is useful in a
cooling application to indicate the nonproductive portion of the heat flow. In a heating
application, the interpretation of dissipated power is less useful.
+ — Positive electrical port
Electrical conserving port associated with the positive terminal.
- — Negative electrical port
Electrical conserving port associated with the negative terminal.
A — Thermal port
Thermal conserving port. When the block acts as a cooling device, a positive current causes heat to flow from port A to port B, cooling port A relative to port B.
B — Thermal port
Thermal conserving port.
Seebeck coefficient — Thermoelectric sensitivity coefficient
Measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material.
Total electrical resistance — Resistance between the electrical ports
Total electrical resistance between the + and - ports.
Thermal conductance — Conductance between the thermal ports
Thermal conductance between the A and B ports.
C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.
Introduced in R2018b