Installation Setup and Configuration
The Hardware Setup screen provides step-by-step instructions to install and configure Simulink® Support Package for Raspberry Pi™ Hardware. For more information on the installation process, see Install Simulink Support Package for Raspberry Pi.
Learn how to establish communication between host computer and your Raspberry Pi hardware.
|Get host name, user name, password, and build directory|
Install support for Raspberry Pi hardware.
Run Simulink models on Raspberry Pi without providing a password.
Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.
Configure Network Settings
Configure the network settings of your Raspberry Pi hardware.
You can use any of these methods to know the IP address of your Raspberry Pi hardware.
When Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.
Access and Configure Linux Operating System
Open a serial command-line session with Raspberry Pi hardware.
Set up Raspberry Pi hardware as a Linux® desktop or terminal.
This example shows you how to run Linux® shell commands on your Raspberry Pi™ hardware.
Extend Linux partition on the SD card for Raspbian Linux image.
Configure Parameters on Configuration Parameters Dialog Box
This section describes about the model configuration parameters.
Include additional capabilities for code generation.
Configure Simulink Online
Configure, connect to, and control Raspberry Pi hardware in Simulink Online™.
Take steps to secure your Raspberry Pi in Simulink Online.