The Communications Toolbox™ Support Package for USRP™ Radio supports Ettus Research™ devices listed in this table and has been tested on devices using Supported Daughter Cards. Support might also extend to other UHD™-based radios and daughterboards from Ettus Research.
National Instruments® radios equivalent to the listed Ettus Research radios are also supported. For more information, see https://kb.ettus.com/Mapping_Between_ER-USRP_and_NI-USRP_Product_Numbers.
USRP Bus Series (B200 and B210*)
Collectively referred to in this documentation as B-series.
USRP Networked Series (N210 and N200) from Ettus Research and USRP-292X and USRP-293X Series from National Instruments
Collectively referred to in this documentation as N2xx.
USRP Networked Series (N300*, N310**, N320*, and N321*)
Collectively referred to in this documentation as N3xx.
USRP X Series (X310* and X300*) from Ettus Research and USRP-294X and USRP-295X Series from National Instruments
Collectively referred to in this documentation as X3xx.
X3xx radios with the TwinRX daughterboard support up to four-channel reception with phase synchronization present between all channels.
* SISO and 2x2 MIMO modes are supported.
** 4x4 MIMO mode is supported.
These daughter cards are used with USRP2, N2xx, N3xx, and X3xx series radios. Support might also extend to other UHD-based radios and daughterboards from Ettus Research.
TwinRX is compatible with X3xx series radios only.
The blocks and System objects use a specific version of the UHD driver. The FPGA binaries on your USRP radio must match the specific version of the UHD drivers supported by the current release.
The following MathWorks products are required for using Communications Toolbox Support Package for USRP Radio.
DSP System Toolbox™
Signal Processing Toolbox™
Communications Toolbox Support Package for USRP Radio