Example c2000 concerto on the leds
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
Hi,
I tried this example of the LEDs on Matlab.
I have a problem in managing the LEDs . From datasheet card there is no correspondence with the LEDs indicated by example. Infact there is led 1 with GPIO 70 but not LED 2 .
Also, if I try to use the C28x processor to turn on the LED 3 ( GPIO71 ) nothing happens .
Who can help me ?
Thank you
Luigi
1 Commento
Andres
il 14 Giu 2016
I have the same issue. I tested the board using CCS Studio and LED2 correspond to GPIO 70. So I think the model is ok.
Also If I follow the M3 example everything works . The issue comes when you try to load the C28x model into the processor. Is not loading at all. These are the last two lines I got form the diagnostic viewer. ### Successful completion of code generation for model: led_blink_f28m35_c28 Build process completed successfully ------ I think it should attempt to load and Run but nothing happens.
Risposte (1)
Andres
il 15 Giu 2016
This Worked for me :
Reinstall the support packages for C2000 Concerto
Install the latest version of ccs studio.
Change in configuration parameters in the code generation pane, the Toolchain settings , Toolchain = Texas Instruments Code Composer Studio V6 (C2000)
I hope this can help.
0 Commenti
Vedere anche
Categorie
Scopri di più su Deployment, Integration, and Supported Hardware in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!