Simulink &TI f28379d ADC configuration
18 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello everyone
I would like to acquire a signal from a current sensor (ACS712) using TI f28379d & Simulink, but I can not get a stable data from the ADC even using a constant and known voltage source.
Specifically, the sensor should measure the discharge current of a battery (2.5 A) by performing readings with a frequency of 10-100 Hz.
Any ideas on how to configure the parameters to make a consistent reading?
Thanks, Tommaso.
1 Commento
SHAMSUL AREFEEN AL MAHMUD
il 20 Apr 2021
Hello, did you able to get any solution for this issue? I am using the similar kind of current sensor and trying to connect with F28379D ADC. I ma having problem with configuring the ADC pin. I tried to get some values in ADC using software triggering but not working at all. I was giving 2 or 3 volts supply from a dc source.
Risposte (1)
Yash
il 7 Lug 2022
To get a stable output you can use a relay block available in Simulink. This may help you to get a stable value within the range you specify.
0 Commenti
Vedere anche
Categorie
Scopri di più su Sources in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!