How can I change axes labels?

from this:

 0 ^
 1 .
 2 .
 3 .
 4 .
 5 .
 6 .
 7 .
 8 .
 9 .
 10.....................>
  0 1 2 3 4 5 6 7 8 9 10

to this:

 10^
 9 .
 8 .
 7 .
 6 .
 5 .
 4 .
 3 .
 2 .
 1 .
 0 .....................>
  0 1 2 3 4 5 6 7 8 9 10

Thanks.

Answer 1

[Matt Fig]

set(gca,'ydir','normal')

[Tomislav]

But this way my data is upside down. I want to keep the data the way it is.

Thanks

[Matt Fig]

set(gca,'yticklab',flipud(get(gca,'yticklab')))

[Matt Fig]

If that doesn't do what you need, then it sounds like your problem is with the data itself. You should scale and shift the data before plotting....

[Tomislav]

I did it. I messed things up with:

I=flipud(I);

I remove that and added Matt's answer and it was good.

Thank you for your time.

Answer 2

[Azzi Abdelmalek]

yt=get(gca,'ytick');
set(gca,'yticklabel',fliplr(yt))

[Tomislav]

That keep tha data in place, but now when I pick a point with cursor data it shows the old data and it is not a mach with data on screen.

Thanks.

[Azzi Abdelmalek]

I think your comments are contradictory

[Tomislav]

No. Please, try to understand. I have data. It need to stay the way it is. The y label need to reverse, and when I pick a point with cursor data it need to match the changed y label. But it doesnt.

For example:

Old labels. Cursor data click bottom left corner it would show x=0, y=10.

On the new labels it will show the same but it need to show x=0, y=0.

Thanks.

[Azzi Abdelmalek]

If you don't change your data, the data cursor will give the same values.

[Tomislav]

I understand. I thouht that there is some way that cursor follows the axis labels.

OK, thank you very much.

[Azzi Abdelmalek]

I did'nt say there is no way to make it looks like it following axis labels, but I don't understand what is your goal, perhaps there is better ways.

[Tomislav]

I explained my goal in upper comment. Ok, here is the whole situation. I have horizontal, saggital and coronal slice. I have put slices each in his axes and additionally all three in one 3D axes. Now I have to be able pick two points, either from 3D coordinates or from individual slice and they has to mach. But it doesnt. Y label on individual slice is upside-down in relation to the same slice in 3D coordinate system.

Thanks.

[Tomislav]

I figure it out. It was my fault. Messed up things with flipud function.

Thank you Azzi for your time and patience.