How can I remove the dc component from an Image?
9 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
I wrote this code, it is right?
subplot(2,2,1);
I = rgb2gray(imread('L3S3T2.jpg'));
imshow(I);
FT = fft2(I);
FT(1,1) = 0;
subplot(2,2,3);
I2 = ifft2(FT);
imshow(I2);
0 Commenti
Risposte (3)
Tricky
il 8 Mag 2012
If I'm not wrong the dc component removal from image can also be done like this
I = rgb2gray(imread('L3S3T2.jpg'));
dc=mean2(I);
I1=I-dc;
imhsow(I1);
Can someone explain if there is any difference between the above mentioned Fourier method and this method.
2 Commenti
Bjorn Gustavsson
il 8 Mag 2012
Numerical precision and computation time - though the second might not be too bad...
...I can't see any reason to go through all that fft-ing just to remove the average.
Ivan van der Kroon
il 18 Mag 2011
class input for fft2 should be double or single and you are using unit8. I get no errors, but this is probably not the fft2 you desire. Remember that fft2(I)=fft(fft(I).')
You are right though, that the (1,1) element is the zero-frequency or dc. But if this is the only thing you want to do just subtract the mean.
0 Commenti
Image Analyst
il 8 Mag 2012
Just subtract the mean gray level, being sure to cast the image to single to allow negative values:
meanGrayLevel = mean2(I); % This is a double.
no_DC_Image = double(I) - meanGrayLevel; % Casting I to double is necessary!!!
It's not necessary to use FFT to eliminate the DC components. But if you did want to do it that way, you'd just set the first element of the FT image to zero, and then inverse transform, like you did.
0 Commenti
Community
Più risposte nel Power Electronics Control
Vedere anche
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!