Why does the C24x PWM block's documentation refers to the "Pulse Width" setting when it should refer to the "Duty Cycle" setting in Embedded Target for TI C2000?
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
In the C24x PWM block's documentation page the term "Pulse Width" should be replaced by "Duty Cycle".
Risposta accettata
MathWorks Support Team
il 27 Giu 2009
This is an error within the documentation for Embedded Target for TI C2000 within the C24x PWM block's section.
The documentation should read as follows:
The value set in Duty Cycle above determines the value in the register.
0 Commenti
Più risposte (0)
Community
Più risposte nel Power Electronics Control
Vedere anche
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!