Electric circuit based on dependent source with simscape

Create an electric circuit with a dependent source in Simscape (MATLAB/Simulink)

Build a circuit where the output voltage source is controlled by the voltage across a resistor.Steps:

1. Open Simulink, create a new model, and add a Simscape > Simscape > Solver Configuration block and an Electrical Reference.
2. Add a Voltage Sensor and a Controlled Voltage Source:

• Found under: Simscape > Foundation Library > Electrical > Electrical Sensors and Electrical Sources

1. Connect a basic resistor and voltage source:

• From: Electrical > Electrical Elements (Resistor)
• From: Electrical Sources (Ideal Voltage Source)

1. Use a PS Gain block to scale the measured voltage (e.g., gain = 2).
2. Connect the voltage measurement to the input of the Controlled Voltage Source via the PS Gain.
3. Use Simulink-PS Converter and PS-Simulink Converter blocks if needed.
4. Close the loop and run the simulation.