Community Profile

photo

tq yu


Last seen: oltre un anno fa |  Attivo dal 2019

Followers: 0   Following: 0

Statistiche

  • First Answer
  • Revival Level 1
  • Thankful Level 1

Visualizza badge

Feeds

Visto da

Risposto
how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
Has been solved ,thanks

quasi 5 anni fa | 0

| accettato

Domanda


how can i send datas(rea-time ,get from udp communication) from the workspace to simulink while the simulation is on?
hi ,everybody there I want to send sensors datas in the matlab workspace derieved from udp communication to simulink model ,to...

quasi 5 anni fa | 1 risposta | 0

1

risposta

Risposto
How to use real time input from workspace in Simulink
hi ,there ,have you solved the problem?I just encounter the similar issue .Below is the similar QS by onther ,wish to help you. ...

quasi 5 anni fa | 0

Risposto
why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
have a look at the similar situation: https://ww2.mathworks.cn/matlabcentral/answers/377250-why-is-measured-joint-velocity-zero...

quasi 5 anni fa | 0

| accettato

Domanda


why the sensing output of the joint block(vel,acce,torque) is all zeros? I set the motion in actuator : provided by input(from workspace) and the torque:automatilcally computed .The manipulata move as expected .
As above . The sensing position is presicely the same as input joints angles from workspace ,but the sensing vel,acce and the t...

quasi 5 anni fa | 1 risposta | 0

1

risposta

Domanda


after import robot from urdf ,how can i sent angles to the joints ,and test my own kinermatic algorithm?
I have a problem and need help. I want to use 'smimport' by simscape or 'importrobor' by robotics robotics system toolbox from ...

circa 5 anni fa | 1 risposta | 0

1

risposta