Shengnan Li

Franklin Electric

Last seen: oltre 2 anni fa | Attivo dal 2016

Followers: 0 Following: 0

Messaggio

Statistica

Visualizza badge

Feeds

Domanda

Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.

oltre 4 anni fa | 0 risposte | 0

0

risposte

Domanda

how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...

quasi 9 anni fa | 1 risposta | 0

1

risposta

Domanda

signal input of orifice/valve
How to specify this input? Thanks,

circa 9 anni fa | 0 risposte | 0

0

risposte

Domanda

Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....

oltre 9 anni fa | 0 risposte | 0

0

risposte

Risposto
'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...

oltre 9 anni fa | 0

| accettato

Domanda

'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...

oltre 9 anni fa | 2 risposte | 0

2

risposte

Domanda

how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...

oltre 9 anni fa | 1 risposta | 0

1

risposta

Domanda

Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...

oltre 9 anni fa | 1 risposta | 0

1

risposta