Community Profile

photo

James Van Zandt


MITRE Corporation

Last seen: 8 mesi fa |  Attivo dal 2011

Contatto

Statistiche

  • Thankful Level 1
  • First Answer

Visualizza badge

Content Feed

Visto da

Domanda


Under Linux, how do I get a menu of figure windows so I can click to raise one window?
I have a MATLAB program that creates several dozen figures. On a Mac, the Windows item in the MATLAB menu brings up a list of w...

12 mesi fa | 1 risposta | 0

1

risposta

Risposto
How do I use Goto in MATLAB
There's no way to jump into a block of code. However, if you need to jump out of, say, several nested IF tests, you can put the...

quasi 3 anni fa | 1

Risposto
Can I switch between individual figure windows with the Apple-Tab key combination in MATLAB?
I have installed MATLAB R2019a, and find that <cmd> ` once again cycles among all open MATLAB windows, rather than just toggling...

quasi 5 anni fa | 1

Risposto
Can I switch between individual figure windows with the Apple-Tab key combination in MATLAB?
I see <command> ~ fails with R2018b also (only toggling between two windows, not cycling among all windows). The workaround is...

circa 5 anni fa | 2

Domanda


Is there a way to prevent Matlab windows from being autoraised in focus-follows-mouse mode?
I prefer the "focus follows mouse" mode (so I can more easily consult one window while typing into a different one), and just up...

circa 9 anni fa | 2 risposte | 5

2

risposte

Domanda


phased array toolbox
The recent Phased Array Toolbox is described at <http://www.mathworks.com/products/phased-array/> Under “STAP” I see only on...

quasi 13 anni fa | 1 risposta | 0

1

risposta