Main Content

Reduce Bandwidth Usage During Code Execution Profiling

This topic shows how you can reduce communication channel bandwidth usage when running software-in-the-loop (SIL), processor-in-the-loop (PIL), or XCP-based external mode simulations with code execution profiling enabled.

Capture Main Profiling Metrics on Target Hardware

For code execution profiling, to reduce the communication channel bandwidth usage during a software-in-the-loop (SIL) simulation, processor-in-the-loop simulation (PIL), or XCP-based external mode simulation, you can capture and store only these profiling metrics on the target hardware:

  • Maximum execution time of code section

  • Average execution time of code section

  • Number of calls to code section

Enable the capture of the main profiling metrics by setting the configuration parameter Save options to Metrics only. At the end of the simulation, Simulink® uploads the metrics from the target hardware to your development computer.

To run a SIL simulation that generates only the main execution-time metrics:

  1. Open the model SILTopModel, which has two subsystems CounterTypeA and CounterTypeB.

    openExample('ecoder/SILPILVerificationExample', ...
                 supportingFile='SILTopModel.slx')

  2. On the SIL/PIL tab, in the Mode section, select SIL/PIL Simulation Only.

  3. In the Prepare section, specify these settings:

    1. System Under TestTop model

    2. SIL/PIL ModeSoftware-in-the-Loop (SIL)

  4. To measure code execution times for the subsystems:

    1. Click .

    2. In the Configuration Parameters dialog box, select Measure task execution time, which provides execution-time metrics for the task generated from the top model SILTopModel.

    3. Set Measure function execution times to Coarse (referenced models and subsystems only), which provides execution-time metrics for the functions generated from the subsystems CounterTypeA and CounterTypeB.

    4. Specify a Workspace variable, for example, executionProfile. If the Data Import/Export > Single simulation output check box is selected, the software creates the variable in the Simulink.SimulationOutput object that you specify.

    5. From the Save options drop-down list, select Metrics only.

    6. Click OK.

  5. In the Prepare section, click Settings. Under Coverage, click the Coverage Collection button off.

  6. In the Run section, click Run SIL/PIL.

To open the code execution profiling report, in the Profiling window, click the displayed link. In section 2, the report displays the profiled code sections as a flattened list.

The software cannot extract the hierarchy of calls to code sections because this information is not stored on the target hardware.

Overhead filtering is not supported when Save options is set to Metrics only.

Display Absolute Time

During an XCP-based external mode simulation, the Simulation Data Inspector displays, by default, streamed signal values and execution-time metrics with respect to simulation time: after the execution of a task, the target application uploads data samples from the profiling buffer and associates all data samples from the profiling buffer with the same simulation time.

There are potential issues with streaming simulation time:

  • During data uploading, memory usage can be suboptimal if the target application uploads the whole profiling buffer even when the profiling buffer contains only a few data samples. The maximum size of the profiling buffer is 255 bytes.

  • Data uploading can slow down the execution of the target application.

If the communication channel for the external mode simulation has a low bandwidth or the target application runs tasks with high sampling rates, the generation of profiling data can exceed data uploading, which leads to data loss.

To improve bandwidth usage during data uploading, specify the display of absolute time:

set_param(modelName, 'CodeProfilingXCPUseAbsoluteTime', 'on')

When the external mode simulation runs, the target application uploads data samples only when the profiling buffer is full. The Simulation Data Inspector displays streamed values with respect to absolute time instead of simulation time.

See Also

| | |

Related Topics