You can configure a model running on the target hardware to detect and notify you of task overruns.
Standard scheduling works well when a processor is moderately loaded but may fail if the processor becomes overloaded. A task overrun occurs when a task is scheduled to execute before a previous instance of the same task has completed.
To enable overrun detection:
In your Simulink® model, select Simulation > Model Configuration Parameters.
In the Configuration Parameters dialog box, select Hardware Implementation.
Set the Hardware board parameter to
In Hardware board settings under the Operating system/scheduler settings group, select the Detect task overruns option.
When a task overrun occurs:
The model continues running, but the effective sample time will be longer than specified.
The model saves diagnostic information to a log file. The name of the log
file is the model name followed by
.log. For example, if
the task overrun occurs when running the
raspberrypi_audioequalizer model, the diagnostic
information is saved to the
raspberrypi_audioequalizer.log file. To view the
diagnostic information, open the log file by entering these commands in the
MATLAB® Command Window:
r = raspberrypi; system(r, 'cat raspberrypi_audioequalizer.log')
ans = **starting the model** Overrun detected: The sample time for the rate 0 is too short.
When an overrun condition occurs, you can correct it using one or both of the following approaches:
Simplify the model.
Increase the sample times for the model and the blocks in it. For example,
change the Sample time parameter in all of your data source
blocks, such as blocks for input devices, from
External mode increases the processing burden of the model running on your board. If the software reports an overrun, disable External mode.