Deployment and Validation

Deploy Simulink^® model on hardware and verify numerical equivalence between MATLAB^® code and generated code

Deployment is typically the final stage of the model-based workflow. The examples in this page enables you to perform code verification and validation with processor-in-the-loop (PIL) simulation. Use real-time execution profiling to check whether generated code meets real-time performance requirements.

Topics

Examples Supporting Texas Instruments C2000 Processors
The following table shows the list of C2000™ Microcontroller Blockset reference examples that are supported for each processor family.
PIL Simulation
Processor-in-the-Loop (PIL) simulation techniques for Texas Instruments hardware board.
Serial Configuration for External Mode and PIL
Configure your model to run in external mode and PIL over different baud rates based on the SCI module.
Detect and Fix Task Overruns on Texas Instruments C2000 Hardware
Understanding and fixing overruns on Texas Instruments^® C2000 hardware.
Log Signals on an SD Card

Log signals from Simulink models on an SD card mounted on the target hardware.
- STEP 1: Prerequisites for Logging Signals
- STEP 2: Configure Board Parameters and Enable MAT-File Logging
- STEP 3: Configure Model to Log Signals on SD Card
- STEP 4: Run Model on Target Hardware
- STEP 5: Import MAT-Files into MATLAB
Exploring TI C2000 Toolchain Options
Utilize TI C2000 toolchains like COFF ABI, EABI, and ARM to generate code.

Troubleshooting

Memory and Signal Logging limitations on SD Card

Memory and signal logging limitations of SD card mounted on Texas Instruments C2000 hardware.

Optimizing Baud Rate Settings for External Mode Communication

Optimize baud rates of SCI-A, on-board FTDI, and windows COM port for external mode communication.

Featured Examples

Code Verification and Validation with PIL

Use Texas Instruments™ C2000™ Processor for code verification and validation using PIL in C2000™ Microcontroller Blockset.

Open Model

Code Verification and Validation with External Mode

Use C2000™ Microcontroller Blockset for code verification and validation using External mode.

Open Model

Code Verification and Validation with PIL on the ARM Cortex M3 Core of the F28M3x Concerto Processor

Use Texas Instruments C2000 F28M3x Concerto Processor for code verification and validation using PIL in C2000™ Microcontroller Blockset.

Open Model

Real-Time Code Execution Profiling

Use C2000™ Microcontroller Blockset for real-time execution profiling of generated code.

Open Model

MAT-file Logging on SD Card for Texas Instruments C2000 Processors

Perform MAT-file logging using Simulink® model on a Micro SD card mounted on Texas Instruments™ C2000™ Microcontroller Blockset.

Open Model