Sharing General Purpose Timers Between C281x Peripherals
TMS320x281x DSP devices have four General Purpose (GP) timers. Each Event Manager (EV) module includes two GP timers:
EVA includes GP Timer 1 and GP Timer 2.
EVB includes GP Timer 3 and GP Timer 4.
You can use the GP Timers independently or to operate peripherals associated with the EV Manager, such as PWM, QEP, and CAP.
The following table describes the timer-peripheral mapping of the c281xlib block library.
GP Timer Use for C281x Peripheral Blocks
|GP Timer 1
|GP Timer 2
|GP Timer 3
|GP Timer 4
Each PWM or QEP peripheral has access to only one timer, while each CAP peripheral has
access to two timers. In the PWM and QEP blocks, you can set the Module
B to determine which
unique timer-peripheral combination the block configures. By comparison, in the
CAP block, you can use the Time base option to select
one of two timers for each CAP peripheral.
Each GP timer is available to multiple peripherals. For example:
PWM1-PWM6 and CAP1-CAP3 share GP Timer 1
PWM7-PWM12 and CAP4-CAP6 share GP Timer 3
QEP1-QEP2 and CAP1-CAP3 share GP Timer 2
QEP3-QEP4 and CAP4-CAP6 share GP Timer 4
The PWM, QEP, CAP, and Timer blocks each provide independent access to key timer registers. If the blocks in your model share a specific GP timer, check that the timer-related settings are compatible. If the peripheral settings for a shared timer are not compatible, the software generates an error when you update the model or generate code.
Sharing General Purpose Timers Between CAP and eCAN
The model contains Timer and CAP blocks that both use Timer 1 (GP Timer 1).
Both blocks have the same values for Timer prescaler and
Counting mode. However, each block has different values for
Timer period. The value of Timer period for
Timer 1 is
65535 in the CAP block and
10000 in the Timer block.
Since both blocks configure the same timer, and settings conflict, the software generates an error when you update the model.
Sharing General Purpose Timers Between CAP and SPI
The model contains QEP and CAP blocks that both use Timer 2. In the CAP
block, the Time base option shows which timer the block uses. In the
QEP block, setting Module to
A configures the block to use QEP1–QEP2. GP Timer Use for C281x Peripheral Blocks shows that QEP1–QEP2 use Timer 2.
Currently, both blocks define different clock sources for Timer 2. The
CAP block uses
Internal as a Clock
source. The QEP block, which does not have a configurable
Clock source setting, uses the QEP circuit as a clock source. If you
build the model, the software generates the following error message.
To avoid generating errors when you build the model, change Clock
source in the CAP block to