How to modulate a Light emitting diode (LED) with four different frequencies: 1k, 1.25k, 1.75k and 2k? I want to modulate the LED to use it in indoor positioning process.
6 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
How to modulate four Light emitting diodes (LEDs) with four different frequencies: 1k, 1.25k, 1.75k and 2k? I want to modulate the LEDs to use it in indoor positioning process.
LED1>>>>1K Hz
LED2>>>>1.25K Hz
LED3>>>>1.75k Hz
LED4>>>>2K Hz
0 Commenti
Risposta accettata
Abhijeet
il 6 Mar 2023
Please use the following steps to modulate the four LEDs with different frequencies using MATLAB:
Define the frequency values for each LED as variables:
f1 = 1000; % frequency of LED 1
f2 = 1250; % frequency of LED 2
f3 = 1750; % frequency of LED 3
f4 = 2000; % frequency of LED 4
Define the sampling rate and the duration of the modulation signal:
Fs = 8000; % sampling rate
t = 0:1/Fs:1; % duration of modulation signal (1 second)
Create the modulation signals for each LED using the sine function and create a matrix to hold these signals:
mod1 = sin(2*pi*f1*t);
mod2 = sin(2*pi*f2*t);
mod3 = sin(2*pi*f3*t);
mod4 = sin(2*pi*f4*t);
modulation = [mod1; mod2; mod3; mod4];
Initialize the LEDs using the Arduino interface in MATLAB:
a = arduino();
led1 = 'D3'; % digital pin connected to LED 1
led2 = 'D5'; % digital pin connected to LED 2
led3 = 'D6'; % digital pin connected to LED 3
led4 = 'D9'; % digital pin connected to LED 4
configurePin(a, led1, 'DigitalOutput');
configurePin(a, led2, 'DigitalOutput');
configurePin(a, led3, 'DigitalOutput');
configurePin(a, led4, 'DigitalOutput');
Loop through the modulation signals for each LED and turn the corresponding LED on and off based on the signal value:
for i = 1:length(t)
if modulation(1,i) > 0
writeDigitalPin(a, led1, 1);
else
writeDigitalPin(a, led1, 0);
end
if modulation(2,i) > 0
writeDigitalPin(a, led2, 1);
else
writeDigitalPin(a, led2, 0);
end
if modulation(3,i) > 0
writeDigitalPin(a, led3, 1);
else
writeDigitalPin(a, led3, 0);
end
if modulation(4,i) > 0
writeDigitalPin(a, led4, 1);
else
writeDigitalPin(a, led4, 0);
end
pause(1/Fs);
end
This code will continuously loop through the modulation signals for one second, turning each LED on and off based on the corresponding signal value.
Più risposte (0)
Vedere anche
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!