Arduino Giga R1 compatibility?

I wanted to confirm that the Arduino Giga R1 is not compatible with Simulink/Matlab. This is due to having a dual core STM32H747 main processor. ( Data sheet at arduino: 747xi/g ) Is there anything that can be done to write custom functions/code for this particular chip?

Answer 1

[Francis B.]

Dual core not supported

Answer 2

[Dinesh]

Hi Francis.

As I can see, Arduino Giga R1 is currently not compatible with MATLAB or Simulink.

However, you can still use it in MATLAB/Simulink with the help of the STM32-MAT/TARGET support package.

STM32-MAT/TARGET is a Simulink blockset provided by STMicroelectronics that allows you to generate code for STM32 microcontrollers, including the STM32H747.

It can be found here:

https://www.st.com/en/development-tools/stm32-mat-target.html

Please note that you may need to manually configure the hardware settings for the Arduino Giga R1 board, such as pin connections, clock settings and other peripherals since the board is not directly supported.

[Francis B.]

Thanks, I will have to check this out.

[Joel Eberenz]

Hi there,

same applies to me.

do you have any solutions yet? did you get the board to connect and running?

[Francis B.]

I am unable to build with STM32 settings.

[Francis B.]

Any help would be appreciated:

Here is my STM community post, currently without an answer: https://community.st.com/t5/stm32cubemx-mcus/simulink-and-stm32h747xi/td-p/587514

[Nithin]

STM32-MAT/TARGET is a legacy workflow and supports only the F3 series.