WAIT timeout on image acquisition toolbox
6 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi, I would like to record a video for 5 min using Image acquisition toolbox. I got the error "WAIT reached its timeout before OBJ stopped running." If I remove wait(v), video is not acquired. Could anyone please advise? thanks.
v = videoinput("gentl", 1, "Mono8");
filelocation = "D:\test\mouse 1";
filename = "recording4.mp4";
fullFilename = fullfile(filelocation, filename);
% Create and configure the video writer
logfile = VideoWriter(fullFilename, "MPEG-4");
logfile.FrameRate = 10;
% Configure the device to log to disk using the video writer
v.LoggingMode = "disk";
v.DiskLogger = logfile;
% v.ROIPosition = [0 300 1920 400];
durationinmin = 5;
numFrames = logfile.FrameRate * 60 * durationinmin;
v.FramesPerTrigger = numFrames;
start(v);
% set(v, 'Timeout', 600);
wait(v);
stop(v);
% Wait for all frames to be written to disk
while v.FramesAcquired ~= v.DiskLoggerFrameCount
pause(.1);
end
delete(v)
clear v
0 Commenti
Risposta accettata
Malay Agarwal
il 13 Lug 2023
Modificato: Malay Agarwal
il 13 Lug 2023
Could you try uncommenting the set() line that changes the timeout for v? That will set the timeout to 600 seconds (10 minutes) and should allow the wait(v) to run through without exhausting the timeout. The default timeout is 10 seconds, which is not enough time to capture the 5-minute video. Please see this resource for more information: Create video input object - MATLAB - MathWorks India.
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Image Acquisition Support Packages for Hardware Adaptors (Generic Video Interface) in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!