Azzera filtri
Azzera filtri

High Rotor speed and oscillating troque

4 visualizzazioni (ultimi 30 giorni)
Hassan Ali
Hassan Ali il 24 Apr 2024
Hey,
When running a motor through inverter (both parameterized thus non-ideal), the starting speed in RPM reaches approximately 1500 RPM in 0.02sec and and oscilates, it should increase gradually. Moreover, I have given a load torque signal, but liek speed torque is oscillating instead of become stable even after few seconds.
What could be the issue here. The speed and torque snapshots are attached here.

Risposte (2)

Dr Narayanaswamy P R Iyer
Dr Narayanaswamy P R Iyer il 24 Apr 2024
Hi: It all depends upon the model configuration such as whether the model is open loop or closed loop and whether any speed or torque controllers are used in the model etc.
P.R. NARAYANASWAMY.
DR. N P R IYER
EMAIL: nswamy.iyer@gmail.com
  1 Commento
Hassan Ali
Hassan Ali il 24 Apr 2024
its open loop, no controller is used yet. The switching is done through simple SPWM applied to the inverter.

Accedi per commentare.


Dr Narayanaswamy P R Iyer
Dr Narayanaswamy P R Iyer il 24 Apr 2024
Hi: I can't predict anything unless I am able to see the model.
P.R. NARAYANASWAMY.
DR. N P R IYER
EMAIL: nswamy.iyer@gmail.com

Community

Più risposte nel  Power Electronics Control

Prodotti


Release

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by