single phase and three phase dynamic load
6 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hello all, My first question is why single phase dynamic load is not in simulink library? Another question, when i simulate single phase dynamic load in any mode(continuous,discrete or phaser)its too slow and if i run for longer time, the memory allocated for matlab is full and doesn't for forward. is there any solution for it? but this is not the case with three phase dynamic load. i am quit surprise with this.
is there any way to use three phase dynamic load for single phase dynamic load?
Many thanks
2 Commenti
Tony Castillo
il 6 Nov 2015
Hey my friend I am having the same problem than you had in the past, could you share with my how did you surpassed it?, because i am mired with it. I would appreciate any the colaboration on it.
Sebastian Castro
il 6 Nov 2015
Modificato: Sebastian Castro
il 6 Nov 2015
Tony: In case you missed it, I commented again on your question a few days ago.
Risposte (2)
cr28
il 13 Ago 2012
Samir,
All i can say is when i simulated a 3-phase dynamic load in phasor mode, the simulation was quick.....a lot quicker than continuous mode.
0 Commenti
Vedere anche
Categorie
Scopri di più su Electrical Sensors in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!