Ethernet connexion issue with FIL programmation
1 view (last 30 days)
I'm working on an Altera Stratix IV board with a EP4SGX530KH40C2 device. At the end of the FPGA validation in filWizard with an Ethernet connection, I can see the Rx led lighting up but the Tx led stay not lighting and the ping is failed. I have to notice that the quartus programmer is still opened to keep the Ethernet connection available. Is there someone who already had this issue ?
Thanks for your help.
Tao Jia on 2 Jun 2017
Can you manually ping the board? If that works, you can probably ignore the auto validation error. You should be able to run FPGA-in-the-Loop feature normally by just waiting for the programmer to finish before starting the simulation.
More Answers (1)
Tao Jia on 1 Jun 2017
I assume that you are using the SGMII mode to connect. In that case, the answer to this question might be helpful:
Basically, you'll need to make sure that the quartus programming is opened and running. Also, what is the PHY chip that you are using? There might be some compatibility issue.