- Detect and remove artifacts in raw data.
- Filter raw data based on frequency range of interest (address 50/60 Hz line noise if necessary)
- Perform time-frequency analysis.
EEG pre-processing steps
10 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi, I just want to the exact step in pre-processing EEG signal.
Step 1: convert time-based data into frequency-based data
Step 2: filter the signal to make sure only the wanted frequency is available (eg: 0.5 Hz - 50 HZ)
Step 3: remove any artifacts
Step 4: Divide the clean signal into 4 bands (alpha, beta, theta, delta)
Is these steps correct?
0 Commenti
Risposte (2)
Matt Gaidica
il 8 Mar 2019
What is the goal of your overall analysis? I think the Chronux Toolbox might help you, although, if you just want to get a Fourier analysis, it only takes a few lines of code.
In general, I would modify your protocol:
Provide more information about what you want to do.
0 Commenti
Kosai
il 28 Giu 2012
the Steps are correct but additional to the 4th one : GAMMA-Band must be extracted also ....
2 Commenti
Sepa Abdelrazek
il 15 Lug 2018
can you please tell me how to perform the steps by codes on a data set
Vedere anche
Categorie
Scopri di più su EEG/MEG/ECoG in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!