fscanf warning message
3 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Hi, I am using serial port communication. I can write and read the data but the warning after "fscanf" keep pop up. Below attached the code. Code:
s=serial('COM6','BaudRate',115200,'Parity','none'...
,'DataBits',8,'FlowControl','none'...
,'Terminator','LF/CR');
fopen(s);
fprintf(s,'t');
out = fscanf(s)
Warning: A timeout occurred before the Terminator was reached.
May i know what is the problem?
2 Commenti
Abhirama B A
il 16 Lug 2019
I am also having the same problem even after using the code
set(s, 'TimeOut', 100)
can you help to get rid of this?
Walter Roberson
il 16 Lug 2019
Check the baud rate you are configuring.
Check that the terminator matches.
Use a program such as TeraTerm to verify that you are able to receive data from the port.
Risposta accettata
Jan
il 22 Giu 2012
If the timeout occurred to early, what about increasing the time?
set(s, 'TimeOut', 100)
? But the default of 10 seconds should be long enough... Perhaps the other parameters are not correct?
5 Commenti
wenshuo dong
il 1 Ago 2018
Can you tell me what is the problem? how can I figure it out? I meet the same issue as yours. Thanks!
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Get Started with MATLAB in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!