An error when lanuch Autosar package

C/C++ Coder->Configrue Mode as AUTOSAR Component,the error occured Undefined variable"AUTOSAR" or class "AUTOSAR.Tip" matlab could not open the autosar configuration.

Answer 1

[Anshuman]

Hello Saming,

This typically indicates that the AUTOSAR support is not properly set up or the necessary toolboxes are not installed. Here's how you can address this issue:

• Make sure you have the AUTOSAR Blockset or the necessary features of Embedded Coder installed. You can check and install these via MATLAB's Add-On Explorer.
• Ensure that your MATLAB path is correctly set up to include the AUTOSAR libraries. You can reset the MATLAB path to default by executing:

restoredefaultpath;
rehash toolboxcache;

• If the toolboxes are installed and licensed, try opening the AUTOSAR Configuration Editor again. Open your Simulink model. Navigate to the "AUTOSAR" tab in the Simulink toolstrip. Click on "Code Interface" or "AUTOSAR Component" to configure the model.

Hope it helps!