Engine cooling system (thermal fluid)

In the engine cooling system, we have bypass hose as pipe(TL) so the error i am getting is the outlet pressure according my values cannot run the simulation and it is showing that at the outlet port (B) the pressure is less than th minimum valid pressure.

So how can i change the minimum pressure defined in the pipe (L) or how can i rectify this problem.

[SITTI NUR ATHIRAH ALAM SHAH]

Hey..have you find the solution? . cause i still not get it

[sai srinivasa chaitanya Dasari]

changing the pipe area can vary pressure try to change it if pressure is your concern

Answer 1

[Just Us]

There are two possibilities to overcome this problem: Either you enlarge your fluid flow, which means that you raise the "input pressure" or you go to your fluid properties and define temperatures and densities and internal energies and so on for lower pressures than occuring at port B

[Shivam Atre]

Thankyou for the respone.