enable log signals through command line.

I have several reference models which has logging/test point signals. I use Simulink Signal Logging Selector to enable/disable these signals but I would like to do this through the command line. How do I do this? I have tried Simulink.SimulationData.ModelLoggingInfo.createFromModel. What do i do after this? I also then tried findSignal but it always comes back with an empty array.

Answer 1

[Albert Yam]

I remember doing this before, but I can't find the code. I had to : 1) find the block 2) get the line (out of the block) 3) go back and find the source port 4) set your options there

lh=get_param(gcb,'LineHandles');
lhh=get_param(lh.Outport,'Handle');
sph =get_param(lhh,'SrcPortHandle');
set_param(sph,'DataLogging',1);   %this changed for newer versions I think
get_param(sph,'ObjectParameters') %there will be other things you will want
                                  %decimation, limit results to last XX points

Edit:I'm using Simulink 6.6.1, so things might be different now.

Answer 2

[Cou]

I realize this is an old thread and an answer has been accepted, however it appears at the top of google search results. I thought I'd add a method that preserves the logged signal in the Simulink model but programmatically disables logging. The code below is essentially the same as unchecking the "DataLogging" boxes in the Simulink Signal Logging Selector. Make sure logging mode is set to "Override signals." This tutorial was helpful as well: Log Data in Library Charts

mi = Simulink.SimulationData.ModelLoggingInfo.createFromModel(gcs);
for i = 1:numel(mi.Signals)
    mi.Signals(i).LoggingInfo.DataLogging = 0;
end
set_param(gcs, 'DataLoggingOverride', mi)

[Mariam Achraf]

Hello,

which version are you using please ?,as I can not seem to find this option 'DataLoggingOverride' any where in the data Import window

[Cou]

I am using 2016b.