Convolution Computations results for a system response.
2 visualizzazioni (ultimi 30 giorni)
Mostra commenti meno recenti
Prasad Edirisuriya Mudiyanselage
il 16 Set 2019
Commentato: Prasad Edirisuriya Mudiyanselage
il 16 Set 2019
Can anyone tell the difference of these plots that I used following two codes to plot the results of convolution computations given and need to know the reason for having following difference?
I have attached the results I got for these codes.
0 Commenti
Risposta accettata
Bruno Luong
il 16 Set 2019
Modificato: Bruno Luong
il 16 Set 2019
You make few mistakes, indexing and flipping (see careful conv documentation, the subtility is there, though TMW never mention whereas CEIL or FLOOR must be applied on even-length kernel, shame on them).
This code will show the correction and match both calculations (roundoff beside)
n=[1:1:1000];
s=10*cos(0.05*n);
N=randn(1,1000);
x=s+N;
h=0.1*ones(1,10);
y = conv(x,h,'same'); % 'same'
yy = zeros(1,length(n));
for i = 1: length(n)
for j = 1:length(h)
k = i-j+ceil((length(h)+1)/2); % shift by ceil(...) which correspond to "same"
if k>=1 && k<=length(x) % overflow check
yy(i) = yy(i) + h(j)*x(k);
end
end
end
close all
figure
plot(yy)
hold on
plot(y)
Related post here
Più risposte (0)
Vedere anche
Categorie
Scopri di più su Whos in Help Center e File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!