The model has to output the value of battery charge increase at the end of braking. So there will be an interval when I brake and the battery state of charge increases. Example: start t=1 SOC=0, end t=20 SOC=5. When braking is finished I must have SOC=5 as output. As soon as I have sent this signal as output I must have zero and wait for the new braking and indicate in the output what is the accumulated state of charge (SOC).
I was thinking of using the enabled system. Where as input I have Mode (which can take values 0=acceleration 1,2=braking) and delta SOC which is a cumulative value of my battery state of charge (i.e. how much it is charging).
I set the switch so that it gives me a value of 0 when Mode is non-zero and thus have an increase in SOC. As soon as Mode is equal to zero it means that I have finished braking and I can send the system what I have accumulated.
However, the system is not working, and furthermore I would like to understand how the accumulative SOC signal can be sent at the initial instant of mode=0 and not for the entire interval.
