MATLAB GUI for Arduino LED blinking

This GUI is used to toggle LED connected to pin 13 of Arduino uno

This interactive GUI consists of a webcam display which is only used to view the Arduino UNO in the frame(if required). The interface consists of four butons, 1.Connect arduino ,which is used to establish serial communication 2. ON , to turn ON the LED 3.OFF, to turn off LED 4.Exit button , to exit the program.
The program required to be uploaded before executing this files:
Note: Make sure the COM port number is correctly entered in MATLAB program

const int ledpin=13;
int recValue;

void setup()
{
Serial.begin(9600);
pinMode(13, OUTPUT);
}

void loop()
{
if(Serial.available()>0)
{
recValue=Serial.read();

if (recValue == 100) // If use will send value 100 from MATLAB then LED will turn ON
{
digitalWrite(ledpin, HIGH);
}
if(recValue == 101) // If use will send value 101 from MATLAB then LED will turn OFF
{
digitalWrite(ledpin, LOW);
}
}
}