Community Profile

photo

Taimur Zaman


Last seen: circa 2 mesi fa |  Attivo dal 2018

Followers: 0   Following: 0

Statistiche

  • Explorer
  • First Review
  • Thankful Level 1
  • First Answer
  • Revival Level 1

Visualizza badge

Feeds

Visto da

Risposto
Code generation information file does not exist.
I had this problem from long time. There is problem with matlab version 2022b and 2023 onwards. They dont set automatically the ...

circa un anno fa | 0

Risposto
Cannot connect to Launchpad TMS320F28379D Development Kit
Hi, Make sure you have CCS 9 or older version for F2379D Version. Made my controller restart and updated the baud-rate. for ...

circa 2 anni fa | 0

Risposto
wavelet transform to find fault location
Usman, can we work on it and exchane ideas?

quasi 3 anni fa | 0

Risposto
Why do I get a "Failed to connect to the target" error when trying to run in external mode with a TI F28379D ControlCard?
whenever i run my model; each time, i try this code and it works for me. try to keep sampling rate low, as changing it from 0.1 ...

oltre 5 anni fa | 0

Domanda


how to control phase shift of pwm for dual active bridge?
How do i connect the pid output to pwm block, to control the phase shift. Or i have to implement some kind of othre algorithm.?

oltre 5 anni fa | 1 risposta | 0

1

risposta

Risposto
Solving coupled equations in Matlab
https://sites.google.com/site/srcombexp/home/matlab-script-help/solution-to-multiple-couples-non-linear-equations

oltre 5 anni fa | 0

Domanda


Matlab device driver block, stepimpl method help please
Hi i am having problem with matlab device driver block. My code is generating pwm signals with feedback from hardware. i m maki...

oltre 5 anni fa | 0 risposte | 0

0

risposte

Risposto
I am working on the simulation of a Solid State Transformer.It has three modules- the PWM rectifier, the Dual Active Bridge Converter and the Inverter.The modules work well individually but the input current gets distorted with the whole system.Why??
Dear Partha Sarthy, As per my knowledge, your input current is distorting because that you are using very high frequency transfo...

quasi 6 anni fa | 1

Domanda


Updating Arduino Registers Value From Simulink
HI Everyone! I am working currently on the transformation of Arduino code to Simulink blocks. However, at some points in my cod...

quasi 6 anni fa | 1 risposta | 0

1

risposta

Domanda


How to Design High Frequency Transformer and its parameters
Hi, i am working on dual active bridge, i am facing problem in designing the high frequency transformer. what block should i use...

circa 6 anni fa | 1 risposta | 0

1

risposta