Statistica
RANK
194.808
of 300.829
REPUTAZIONE
0
CONTRIBUTI
5 Domande
3 Risposte
ACCETTAZIONE DELLE RISPOSTE
20.0%
VOTI RICEVUTI
0
RANK
of 171.210
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
How to design voltage regulator in Simulink?
Did you find the solution ?
circa un anno fa | 0
Domanda
Why do the load flow results from the powergui block in my IEEE 34 model only appear for buses before the voltage regulator, and how can I fix this?
While working on an IEEE 34 model and using the load flow analyzer from the powergui block, I noticed that the load flow results...
oltre un anno fa | 1 risposta | 0
1
rispostaDomanda
What is the best method to model or utilize the built-in model for a three-phase voltage regulator in MATLAB Simulink, specifically for the IEEE 34 distribution network?
What is the best method to model or use the built-in model for a three-phase voltage regulator in MATLAB Simulink, specifically ...
oltre un anno fa | 1 risposta | 0
1
rispostaDomanda
Assistance with Load Flow Analysis in IEEE 34 Distribution Network on MATLAB-Simulink
Hello, I am working with the IEEE 34-bus distribution network in MATLAB-Simulink. When running the load flow analysis after set...
oltre un anno fa | 1 risposta | 0
1
rispostaDomanda
Problem with the Transformer model in matlab simulink
When I run the simulation without the transformer block, everything works fine. However, when I add the transformer to the netwo...
oltre un anno fa | 0 risposte | 0
0
risposteHow to get the simplified integral after using "piecewise"?
The answer: int((sin(x))*sin(n*x),x,0,w,'IgnoreSpecialCases',true)
oltre 4 anni fa | 0
| accettato
Domanda
How to get the simplified integral after using "piecewise"?
Good morning, I wrote a code by using "piecewise" function , but after that when I tried to get the result of any integration ,...
oltre 4 anni fa | 1 risposta | 0
1
rispostaHow to convert a structure into a individual double elements
Question How to change struct 1x2 to double 1x1?
quasi 5 anni fa | 0
