Community Profile

photo

MM


Last seen: quasi 4 anni fa |  Attivo dal 2019

Followers: 0   Following: 0

Statistiche

  • Thankful Level 1
  • Revival Level 1

Visualizza badge

Feeds

Visto da

Domanda


How to follow a SimScape Multibody model in Mechanics Explorer
I made a model in SimScape Multibody with two connected bodies that moves along +X and I would like to capture the movement of t...

quasi 4 anni fa | 1 risposta | 0

1

risposta

Domanda


Damping and frequency from simulation data
I have some simulation data, for example y in the attachment. I can manually calculate the damping and frequency with logarithmi...

circa 4 anni fa | 1 risposta | 0

1

risposta

Domanda


How to make a 3D plot of 41x41x41 datapoints
I have done some simulations creating 41x41x41 datapoint and I would like to plot this in 3D. The points are either 1 (good) or ...

circa 4 anni fa | 2 risposte | 0

2

risposte

Risposto
Fit line on an edge of datapoints area
It isn't possible what I'm trying to do?

circa 4 anni fa | 0

Domanda


Fit line on an edge of datapoints area
Not the best title but I didn't know a better one. My question, I have some datapoints of 0 and 1 and I would like to know if (...

circa 4 anni fa | 2 risposte | 0

2

risposte

Risposto
How to find a complex eigenvalue of a matrix
A bit late but I fixed it, I could do it without filtering the pairs

circa 4 anni fa | 0

| accettato

Domanda


How to find a complex eigenvalue of a matrix
I want to find the highest complex eigenvalue of a matrix A. For example: lambda = eig(A) I'll get: lambda = 2.6955 + 0...

oltre 4 anni fa | 1 risposta | 0

1

risposta

Risposto
Bus signal: save and load
Thank you it works! However I do have a new problems. When I try do use this method in my real model, I'll get an error "Refere...

quasi 5 anni fa | 0

Risposto
Bus signal: save and load
Hi Sara, Thank you for the file. I've seen the Callbacks code and left it like you uploaded it. I've run test_bus_save.slx firs...

quasi 5 anni fa | 0

Risposto
Bus signal: save and load
Hi Sara, Thank you for the help. I tried to do (or understand) what you said, but I can't get it to work. Can you make an examp...

quasi 5 anni fa | 0

Risposto
Bus signal: save and load
I see I uploaded a file with the wrong configuration. I uploaded a new one. But this one doesn't work either. I don't really ...

quasi 5 anni fa | 0

Domanda


Bus signal: save and load
I have a simulink model from which I want to save a bus signal and load this into another simulink model. I have no problems wit...

quasi 5 anni fa | 7 risposte | 0

7

risposte

Domanda


MATLAB source control using Git > (sub)folders
I've installed and setup Git for my MATLAB/Simulink project using this guide: http://www.datatool.com/downloads/MATLAB_Source_C...

quasi 5 anni fa | 0 risposte | 0

0

risposte