tje_b

Last seen: 5 mesi fa | Attivo dal 2022

Followers: 0 Following: 0

Statistiche

Feeds

Domanda

Why can't Matlab save the acceleration data higher than 8.67KSPS
I used the following codes to save my acceleration data from my Teensy4.1 board connected to my Macbook comport. I find out that...

6 mesi fa | 1 risposta | 0

1

risposta

Domanda

what is wrong with my FFT from a Shaker with accelerometer mounted
I tried to compute the FFT of the data attached to no avail using the FFT code below. The sensor was mounted on a shaker and I a...

8 mesi fa | 1 risposta | 0

1

risposta

Domanda

accelerometer data shows nothing in FFT
I upload the data and the code but when I run it, nothing show up. the accelerometer was connected to a shaker and sampled at ...

10 mesi fa | 3 risposte | 0

3

risposte

Domanda

i tried pulling my data from arduino port but got error. I am a novice
serialPort = 'COM5'; baudrate = 115200; s = serialport(serialPort,baudrate); pause(4); numsamples = 1000; data = zero...

circa un anno fa | 1 risposta | 0

1

risposta

Domanda

FFT of vibration data in real-time
I have transmited my accelerometer data using wifi and Putty. Can I do the FFT of this data in real-time? If yes, some tips p...

oltre un anno fa | 1 risposta | 0

1

risposta

Domanda

How do I plot the FFT of signal from accelerometer
The Sample rate of the accelerometer from the arduino IDE was 833Hz and I placed the accelerometer on a shaker, The shaker has a...

oltre un anno fa | 2 risposte | 0

2

risposte

tje_b

Statistiche

Thankful Level 2

MATLAB Answers

Feeds

1

1

3

1

1

2