Statistica
All
RANK
7.472
of 292.708
REPUTAZIONE
6
CONTRIBUTI
4 Domande
2 Risposte
ACCETTAZIONE DELLE RISPOSTE
25.0%
VOTI RICEVUTI
1
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Domanda
R2013a 64 Bit + Stateflow + Simulink + MinGW + Gnumex = working?
Hi, I wonder if I can use the combination of mentioned programs under Windows 7 64Bit? Does Stateflow work? I have serious...
circa 11 anni fa | 0 risposte | 0
0
risposteRisposto
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
circa 11 anni fa | 0
Domanda
Measure reaction forces in joints and bearings
Hi! I built a model in SimMechnics 2G. It seems to work quite good :) Is there a way to measure the reaction forces or the...
circa 11 anni fa | 1 risposta | 0
1
rispostaRisposto
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
circa 11 anni fa | 1
| accettato
Risolto
Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so: x = [1 2 3 4] Commas are optional, s...
circa 11 anni fa
Risolto
Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...
circa 11 anni fa
Domanda
More information about assembly (or why is something not assembling)
Hi, I wonder if there are more tools in SimMechanics 2G than the Explorer who simply states: Joint x ist bad. For example, so...
circa 11 anni fa | 1 risposta | 0
1
rispostaDomanda
How to interface Stateflow charts with Bus signals
Hi, In my model a stateflow chart has a lot of inputs and outputs. Is it possible to feed a bus signal directly into or ou...
circa 11 anni fa | 2 risposte | 0