photo

Armin Lensker


Attivo dal 2016

Followers: 0   Following: 0

Statistica

  • Thankful Level 2
  • Thankful Level 1

Visualizza badge

Feeds

Visto da

Domanda


Real-time data exchange of Simulink and Zynq-7000
Hello! I want to measure some signals using one of the various development boards (ZedBoard, MicroZed, ZC702 Evaluation Board...

oltre 6 anni fa | 1 risposta | 0

1

risposta

Domanda


Simulink eQEP block for speed calculation with C2000 MCU
Hi all! ;) I am working with a C2000 Microcontroller from Texas Instruments. I try to calculate the shaft speed of a DC machi...

oltre 7 anni fa | 4 risposte | 0

4

risposte

Domanda


Serial Send / Serial Receive in Simulink with a TI C2000 MCU
Hi all! ;) In the last week I successfully established a serial communication between my computer and an F28069M MCU using "S...

oltre 7 anni fa | 3 risposte | 0

3

risposte

Risposto
C2000 SCI Communication: Always Timeouts?
The solution to my problem was posted in the forum I linked in the comment to my question.

oltre 7 anni fa | 0

| accettato

Domanda


C2000 SCI Communication: Always Timeouts?
Hi all! ;) I am trying to establish serial communication between my computer and my F28069M-LaunchPad via USB cable. My aim i...

oltre 7 anni fa | 1 risposta | 1

1

risposta

Risposto
Error when building code for C2000 MCU in external mode
Hi all! ;) I found a solution to my problem: There was something wrong with my xmakefilesetup. A few days ago I set up the c...

oltre 7 anni fa | 0

| accettato

Domanda


Error when building code for C2000 MCU in external mode
Hi all! ;) I want to run a Simulink model on my Texas Instruments F28069M (C2000 Microcontroller) in exernal mode, so that I ...

oltre 7 anni fa | 3 risposte | 0

3

risposte

Domanda


Running Simulink models on a TI C2000 MCU
Hello, I have a problem concerning Simulink Coder. I wanted to compile a simple Simulink model to run it on the C2000 Microco...

oltre 7 anni fa | 1 risposta | 0

1

risposta

Domanda


Induction machine model with saturation
Hi! ;) I'm currently running a simulation of an induction machine using the Simulink add-in "PLECS". Don't worry, I don't hav...

circa 8 anni fa | 0 risposte | 0

0

risposte