Surojit Sen
Followers: 0 Following: 0
Statistica
RANK
276.968
of 295.467
REPUTAZIONE
0
CONTRIBUTI
7 Domande
1 Risposta
ACCETTAZIONE DELLE RISPOSTE
42.86%
VOTI RICEVUTI
0
RANK
of 153.912
CONTRIBUTI
0 Problemi
0 Soluzioni
PUNTEGGIO
0
NUMERO DI BADGE
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Domanda
Freewheeling diode causing error in Full-Bridge Inverter model
Hi, please see the attached Simulink model. Its a simple full-bridge inverter producing quasi-square alternating voltage at the ...
oltre 7 anni fa | 0 risposte | 0
0
risposteDomanda
How to dynamically change a block parameter value during simulation run-time?
I have been trying to find an easy way of doing this, but have failed till now. The problem is like this: I want to implement a ...
oltre 7 anni fa | 1 risposta | 0
1
rispostaDomanda
What Simulink tool should I use to break a continuous signal into its frequency components?
I have a continuous signal which is composed of multiple frequency components, not necessarily harmonics. How do I separate this...
oltre 7 anni fa | 1 risposta | 0
1
rispostaDomanda
'Degenerate Mass on Follower Side' issues?
[Please refer to the screenshots, as the portal does not allow attaching Simulink (.slx) models here] *** EDIT MADE TO QUESTION:...
circa 8 anni fa | 0 risposte | 0
0
risposteCan a joint produce 'Sensing' outputs resolved in the follower frame?
Got the answer after a bit of scouring the library, simply use a 'Transform Sensor' in parallel to the joint, and output whateve...
circa 8 anni fa | 0
Domanda
Can a joint produce 'Sensing' outputs resolved in the follower frame?
Take for example the planar joint, can I get the position, velocity, acceleration of the follower frame resolved in the follower...
circa 8 anni fa | 1 risposta | 0
1
rispostaDomanda
Pacejka Tire Model (Magic Formula) for lateral dynamics?
The Magic Formula block in Driveline is excellent, but only caters to the longitudinal forces/acceleration of the tire. I unders...
circa 8 anni fa | 2 risposte | 0
2
risposteDomanda
How do I set block parameter value using a Mask property?
I want to convert a Suspension block subset into a generic suspension Mask. This mask would have a few popups. A particular bloc...
circa 8 anni fa | 1 risposta | 0