Erman Korkut

MathWorks

Attivo dal 2011

Followers: 0   Following: 0

Messaggio

Statistica

  • Knowledgeable Level 2
  • First Answer

Visualizza badge

Feeds

Visto da

Risposto
Why is uncertainty parameter outside input-output loop not linearised in robust control toolbox?
Hi J. Van, This is the expected behavior. When the uncertainty is not in the linearization path given the input and output lo...

oltre 10 anni fa | 0

| accettato

Risposto
Model Reference Blocks and systune
Hi Jim, I would recommend to make sure that the blocks you specify to be tuned (and all their parent models all the way to th...

oltre 10 anni fa | 0

Risposto
How does source affect Simulink's frequency response estimation?
Hi Lauri, This is a common issue frequency response estimation users encounter. Simulink Control Design offers ways to find a...

oltre 11 anni fa | 1

Risposto
Control Design: Linearization at multiple operating points simultaneously
Another alternative would be to use "Linearize At..." menu item in Operating Point drop down (2nd from the top, below "Model Ini...

oltre 11 anni fa | 0

Risposto
how to copy LTI viewer figure to clipboard?
Hi Noam, This is an excellent suggestion, currently it is not possible to do it inside the linear analysis tool. But as a wor...

quasi 13 anni fa | 1

| accettato

Risposto
Integers in control loops
Hi Mark, How are you rounding your controller output? If you are using the quantizer block, there is a checkbox for "treat ga...

oltre 13 anni fa | 1

| accettato

Risposto
Linearization gives accurate results with Simulink Control Design but not with linmod
The underlying reason can be a lot of things for the difference: # If you have more than one input/output points, the channels ...

oltre 13 anni fa | 0

Risposto
(Simulink/MPC) Unable to linearize with an if...else loop
Hi Tan, The Embedded MATLAB function blocks are linearized using numerical perturbation by default. Your code seems to indica...

oltre 13 anni fa | 1

Risposto
Computing Operating point using Simulation Snapshots
Hi Tan, To stop the model from trying to initialize from a no longer existent operating point, you can go to the menu in Simu...

oltre 13 anni fa | 1

| accettato