Statistica
All
RANK
168.495
of 300.763
REPUTAZIONE
0
CONTRIBUTI
1 Domanda
1 Risposta
ACCETTAZIONE DELLE RISPOSTE
0.0%
VOTI RICEVUTI
0
CONTRIBUTI
0 Post
CONTRIBUTI
0 Pubblico Canali
VALUTAZIONE MEDIA
CONTRIBUTI
0 Punti principali
NUMERO MEDIO DI LIKE
Feeds
Risolto
Make a half wave rectifier
Produce a signal that outputs the given sine wave source when it is greater than zero and outputs zero when it is less than zero...
oltre 7 anni fa
Risolto
Find the sum of all the numbers of the input vector
Find the sum of all the numbers of the input vector x. Examples: Input x = [1 2 3 5] Output y is 11 Input x ...
oltre 7 anni fa
Risolto
Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...
oltre 7 anni fa
Risolto
Make a full wave rectifier
Produce a full wave rectifier waveform for the given sine wave source. For a sine wave input, the output of the full wave rec...
oltre 7 anni fa
Risolto
Add offset to a signal
Produce the following signal: <<http://blogs.mathworks.com/images/seth/cody/add-offset-eqn.png>> You should see a downward...
oltre 7 anni fa
Risolto
Produce a cosine wave
Produce the following signal: <<http://blogs.mathworks.com/images/seth/cody/cosine-eqn.png>>
oltre 7 anni fa
Risolto
Connect blocks in a model
Connect the blocks in the model to produce the following signal: <<http://blogs.mathworks.com/images/seth/cody/connect-blocks...
oltre 7 anni fa
Risposto
Delete all highlight for simuling GoTo and From block
You can open your model, save the code below in m file and Run it. %===================================================...
Delete all highlight for simuling GoTo and From block
You can open your model, save the code below in m file and Run it. %===================================================...
oltre 7 anni fa | 0
Risolto
Add a block to a model
Produce the following signal: <<http://blogs.mathworks.com/images/seth/cody/add-block-eqn.png>> In this case, the slope of...
oltre 7 anni fa
Domanda
doubleからsingleのキャスト精度の向上方法？
添付画像みたいのキャスト処理をSimulinkモデルで実装してみましたが、 8.333333333333333(double)⇒8.3333330154419(single)になる理由は何でしょうか。 2進数⇔10進数の変換結果が約8.33333331...
oltre 7 anni fa | 1 risposta | 0
