Get Started with the Virtual Vehicle Composer
The Virtual Vehicle Composer app enables you to quickly configure and build a virtual vehicle that you can use for system-level performance testing and analysis, including component sizing, fuel economy, battery state of charge, drive cycle tracking, vehicle handling maneuvers, software integration testing, and hardware-in-the-loop (HIL) testing. Use the app to enter your vehicle parameter data, build a virtual vehicle model, run test scenarios, and analyze the results.
The virtual vehicle model uses sets of blocks and reference application subsystems in Powertrain Blockset™, Vehicle Dynamics Blockset™, and Simscape™ add-ons. Virtual Vehicle Composer simplifies the task of configuring the architecture and entering parameter data.
Open the Virtual Vehicle Composer App
To open the app, do either of the following:
MATLAB® Toolstrip: On the Apps tab, under Automotive, click the Virtual Vehicle Composer app icon .
MATLAB command prompt: Enter
Virtual Vehicle Composer Workflow
To configure, build, operate, and analyze your virtual vehicle, use the Composer tab. To get started with an example, click New .
For this example, follow the workflow steps
to build a four-wheeled electric vehicle (EV), operate it in a
drive cycle, and analyze the results.
|Configure Virtual Vehicle Data
Data and Calibration
Specify the chassis, tire, brake type, powertrain, driver, and environment. For each selection, enter the parameter data describing it.
Scenario and Test
Construct a test plan including one or more virtual vehicle test scenarios. Options include drive cycles for fuel economy and energy management analysis, and vehicle handling maneuvers.
Select the model signal data to log while testing your virtual vehicle. Options include energy-related quantities, vehicle position, velocity, acceleration, and many others.
You can also set the default signals for further tests.
Build your virtual vehicle. When you build, the Virtual Vehicle Composer creates a Simulink® model that contains the vehicle and powertrain architectures and parameters you specified, and associates it with the test plan.
Run Test Plan
Simulate your model according to your test plan and log the resulting output data.
To operate the model, use the Run Test Plan button in the Operate section on the Composer tab.
Simulation Data Inspector
Use the Simulation Data Inspector to view and inspect the data signals that you logged.
You can store your data for further processing.