Configure Virtual Vehicle Scenario and Test
Before completing this step, see Configure Virtual Vehicle Data.
Next, use the Scenario and Test tab to configure your virtual vehicle test plan. The available options depend on the virtual vehicle Powertrain architecture and Model template parameter settings.
If you
set Scenario to Drive Cycle
, you can select:
Standard drive cycles from industry agencies and institutions. The default selection is the
FTP75
drive cycle. Certain drive cycles include gear shift schedules, for example,JC08
andCUEDC
.Wide open throttle (WOT) parameters, including initial and nominal reference speeds, deceleration start time, and final reference speed.
To choose one or more existing drive cycles, click the Scenario and Test tab and follow these steps:
Under Scenario, select
Drive Cycle
.Under Drive cycle, select the desired drive cycle.
Click Add to Test Plan.
If you have selected Combined longitudinal and lateral vehicle
dynamics
(not applicable in this example), you can also choose from
several vehicle dynamics tests under the Scenario tab:
Increasing Steer
Swept Sine
Sine with Dwell
Fishhook
For this example, use the default FTP75
drive cycle.
After completing this step, see Configure Virtual Vehicle Data Logging.