Issues with Flashing Binary Using Hardware Setup Screen

Issue

After you click the Flash Binary button during the Hardware Setup process, the flashing of binary to the Texas Instruments^® mmWave radar sensor becomes unresponsive and no error message appears.

Solution

The flashing of binary requires that you follow the correct steps as displayed during the previous screens of Hardware Setup process. This includes setting the switch positions on the board correctly and resetting the board.

If the flashing of binary to the board becomes unresponsive, open the MATLAB command window and stop the process by pressing Ctrl + C on the keyboard. Then re-launch the Hardware Setup screen and follow the steps corresponding to the Enable Flashing Mode screens correctly (including setting the correct switch positions on the board and resetting the board to latch the switch positions).