![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/175323/image.png)
Simulink : Arduino serial receive 1 byte to control pin13 led ON/OFF
1 visualizzazione (ultimi 30 giorni)
Mostra commenti meno recenti
hi everyone:
Forgive my poor English :)
i first met Simulink these days.and i played all examples in it.
i want arduino can do things below in Simulink;i don't know how to setup up serial receive block.
can someone teach me a little bit :)
-------------------------------
void setup() {
pinMode(13, OUTPUT);
Serial.begin(115200);
}
void loop() {
while(Serial.available() )
if(Serial.read() == '1')
digitalWrite(13, HIGH);
if(Serial.read() == '2')
digitalWrite(13, LOW);
}
0 Commenti
Risposta accettata
Più risposte (1)
Sreeram
il 31 Lug 2014
Hi nt,
The easiest way to get to what you want is to add a Serial Receive block and add a comparator or a switch case block as you seem good for your logic at the output of the block to decide and then glow and LED.
I have attached a simple model snapshot that shows how to achieve a simple case !
Hope this helps
Thanks,
Sreeram Mohan
0 Commenti
Vedere anche
Categorie
Scopri di più su Arduino Hardware in Help Center e File Exchange
Prodotti
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!