How to add the wiring of two resistors in SIMULINK through the MATLAB code

I want to add the wiring of two resistors through the code. As shown in the figure, I first added the Resistor999 module using the code, and then added two resistors, Resistor and Resistor1, and made the connection as shown in the figure in Simulink. I want to add the connection on the right side of Resistor999 and the left side of Resistor1 through the Matlab code.

First use get_param to find out that LConn and RConn in LineHandles should be related to the resistance interface, try to use add_line to add a connection line, but no matter how you try, Invalid Simulink object name is displayed. How to use code for help, thank you!

I would also like to ask how to add the resistor to the specified position through the code, and how to delete the specific connection through the code, thank you!

Answer 1

[Kumar Pallav]

Hi,

You can perform simulink basics modelling from matlab command window. Refer this for more on Programmatic Modeling Basics.

You can use routed lines, port handles, or port IDs to add a line to connect blocks. Refer examples mentioned here to acheive the same.

Hope this helps!

[Kaiyuan Luo]

Thank's for your answer! It really helps a lot.